Infinity Kappa four - Owner's Manual IBII Infinity Kappa four - Mode D'emploi Iiiii Infinity Kappa four - Manual de Propietario D Infinity Kappa four - Manual do Proprietario Ill Infinity Kappa four - A~~ X~ ~ ~A1 Infinity Kappa four- JJ.IPf.M Infinity Kappa four- BIJiif.
~ lnffnit -'1 HARMAN ~ INFIN ITY KAPPA four THANK YOU FOR YOUR PURCHASE ... Your product has been designed to provide you the performance and ease of operation you expect from Infinity. Take time to read this manual before operating or installing your amplifier. Keep it in your glove compartment along with the owner's manual for your car. Put your amplifier sales receipt with other important documents in order to expedite warranty service if needed.
E) Power Input Connectors 0 Speaker Output Connectors Connect speakers to these terminals, observing proper polarity (connect each speaker's positive(+) lead to the appropriate positive(+) terminal, and negative(-) lead to the appropriate negative(-) terminal. • Power: Run 4-gauge power wire from the +12V input to the positive terminal of the vehicle's battery. Insert bare wire into the terminal on the amplifier, then tighten the setscrew with a Phillips screwdriver.
0 t) Auto turn-on selector Preamp outputs The Kappa four amplifier allows you to send a second amplifier line-level signal. Connect a set of RCA patch cables to the line-level inputs on the Kappa amplifier at one end, and to the second amplifier's line-level inputs at the other. 0 Line-level inputs (RCA) If your source unit offers preamp outputs, connect to the front and rear Land R, and subwoofer inputs using RCA patch cables. ··---- @ .....
4& & 4e Power/Protect indicators The power light will illuminate when the amplifier is getting power and playing. Q POWER The protect indicator will illuminate in the event of conditions such as over/under Q voltage, short circuit, amplifier output PROTECT TROUBLESHOOTING PROBLEM: No audio and POWER INDICATOR is off. CAUSE and SOLUTION: No voltage at BATI+ and/or REM terminals, or bad or no ground connection . Check voltages at amplifier terminals with VOM . circuit failure, or excessive heat.
TR04954_A
