Owner's Manual
Table Of Contents
- User Manual
- Table of Contents
- Product Description
- Installation
- Wire Configuration
- General Function of Buttons
- Sign Up Display & Home Menu
- General Operations
- General Settings
- Radio Section Operation
- SiriusXM Section Operation
- Bluetooth Section Operation
- USB Section Operation
- iPodliPhone Operation
- A DX Section Operation
- Troubleshooting
Installation
A mounting gasket has been added inside the package for convenience. Trace
along the outside edge
of
the gasket thus revealing your 3 1/2" cutout.
Mounting Illustration
1.
Avoid installing stereo
below cupholders !
Make sure mounting
substrate is flat to avoid
flexing
of
the plastic.
2. Use the back bracket and
studs to affix the unit. Install
the U bracket behind the unit,
using two nuts per bolt for
ultra hold.
3.
To
avoid possible water
ingress into wire harness
area, route the harness in
the downward direction
as shown above.
NO.
PART
DESCRIPTION
1
RADIO
2
MOUNTING
PLATE
3
MOUNTING
STUDS
4
JAMB
NUTS
5
MOUNTING
BRACKET
6
SPRING
WASHER
) I
~
t:~
t
utu
7
OUTER
NUTS
Instructions:
1.
Install
jamb
nuts (4) loosely on mounting
studs (3), so they will not touch mounting
brackets ( 5) when installed.
I
I:--@
•
~
3
2. Slip mounting bracket (5) on and make
flush with mounting surface (2).
DO
NOT
TIGHTEN
3. Snug spring washer ( 6) and outer nuts (7)
against mounting plate (2).
DO
NOT
TIGHTEN
4. Position
jamb
nuts (4) approximately
1/16" from mounting bracket.
5. Tighten outer nuts (7) completely.