PRELUDE MTS CENTER ™ Owner’s Guide
PLACEMENT The Infinity Prelude MTS center-channel loudspeaker is designed to perfectly complement the Prelude MTS loudspeaker system. It uses identical drivers to provide exceptional dialogue reproduction and a seamless transition between the front channels.The horizontal design allows for maximum placement flexibility. For best results, place the Prelude MTS center-channel speaker on its stand, either on top of or below the television.
WIRING THE SYSTEM Tilting the Speaker... If needed, the enclosed stand allows you to tilt the speaker across a 25-degree range (i.e., 18° maximum up and 7° maximum down), as shown in Figure 3. After placing the speaker, you are ready to connect it to your system. First, turn off all audio-system power. Use high-quality speaker wire to make the connections. Consult the owner’s manuals, included with your amplifier or receiver, for connection and operation procedures. Important! Surround Modes...
SPECIFICATIONS Performance Data... Frequency Response: 80 ~ 22,000Hz (±3dB) 100 ~ 20,000Hz (±1.5dB) Impedance: 4 ohms (±1 ohm) Sensitivity: (2.83V @ 1m) 89dB Recommended Amplifier Power Range: 25 – 500 watts 2nd- and 3rd-Order <1% Harmonic Distortion: (20Hz – 20kHz @ 95dB SPL) Drive Units... Low Frequency: 2 x 5-1/4" (133mm) C.M.M.D.™ drivers, magnetically shielded, neodymium magnet Mid Frequency: 3-1/2" (89mm) C.M.M.D.
