Primus PS212 OM 11/2/06 11:25 AM Page 1 Powered Subwoofer PS212 Owner’s Guide (120V)
Primus PS212 OM 11/2/06 11:25 AM Page 2 IMPORTANT SAFETY PRECAUTIONS Read First! 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. 9.
Primus PS212 OM 11/2/06 11:25 AM Page 3 INTRODUCTION Infinity PS212 Powered Subwoofer The Infinity PS212 powered subwoofer continues Infinity’s longstanding commitment to accurate sound reproduction. Our proprietary technology and engineering resources work together to deliver uncompromised low-frequency performance in any stereo or multichannel home theater system. Unpacking the Subwoofer If you suspect damage from transit, report it immediately to your dealer.
Primus PS212 OM 11/2/06 11:25 AM Page 4 CONTROLS AND CONNECTIONS Rear Panel PS212 Line In Crossover [Hz] Level Phase Power LFE LFE Input 0 ¡ Power Switch ™ Line-Level/LFE Input £ Status LED ¢ Crossover Adjustment ∞ Subwoofer-Level Control § LFE/Normal Selector ¶ Phase Switch 4 PS212 (120V) 1 Green: On Red: Standby 2 50 150 3 Min Max 4 Normal 5 6
Primus PS212 OM 11/2/06 11:25 AM Page 5 SYSTEM CONNECTIONS If you have a Dolby® Digital or DTS® receiver/processor with a low-frequency effects (LFE) or subwoofer output: Set LFE/Normal switch to “LFE.” If your receiver/processor does not contain a Dolby Digital or DTS processor but has subwoofer outputs: Set line-level/LFE switch to “Normal.” NOTE: If your receiver/processor has only one sub out, you may use either the L or R input.
Primus PS212 OM 11/2/06 11:25 AM Page 6 OPERATION Power On Plug your subwoofer’s AC cord into a wall outlet. Do not use the outlets on the back of the receiver. Initially set the Subwoofer-Level Control ∞ to the “min” position. Turn on your sub by pressing the Power Switch ¡ on the rear panel.Turn on your entire audio system and start a CD or movie soundtrack at a moderate level.
Primus PS212 OM 11/2/06 11:25 AM Page 7 SPECIFICATIONS PS212 Frequency Response: 25Hz – 150Hz (±3dB) Maximum Amplifier Output: 400 Watts RMS 700 Watts Peak (20Hz – 150Hz with no more than 0.1% THD) Crossover Frequencies: 50Hz – 150Hz, 24dB/octave, continuously variable Driver: 12" (300mm) MMD® Dimensions (H x W x D): (with grille) 18" x 14-3/8" x 18-3/4" (457mm x 365mm x 476mm) Weight: 44.7 lb (20.
Primus PS212 OM 11/2/06 11:25 AM Page 8 Infinity Systems, 250 Crossways Park Drive, Woodbury, NY 11797 USA 516.674.4INF (4463) (USA only) www.infinitysystems.com Infinity, Harman International and MMD are registered trademarks of Harman International Industries, Incorporated. Dolby is a registered trademark of Dolby Laboratories. DTS is a registered trademark of DTS, Inc. Part No. 406-000-05522-E 11/06 © 2006 Harman International Industries, Incorporated. All rights reserved.
