INFP1614tss4000FMK-OM 10/29/04 11:39 AM Page 1 TSS-4000 TOTAL SPEAKER SOLUTIONS TSS-FMK4000 Owner’s Guide
INFP1614tss4000FMK-OM 10/29/04 11:39 AM Page 2 INTRODUCTION The TSS-FMK4000 allows you to recess a TSS-SAT4000 or TSS-CENTER4000 into the wall. When installed, the speaker will extend beyond the wall approximately 1." Unpacking the Components Finish unpacking the flush-mount kit and check the contents. If you suspect damage from transit, report it immediately to your dealer. Keep the shipping carton and packing materials for future use.
INFP1614tss4000FMK-OM 10/29/04 11:39 AM Page 3 Important Notes: 1) In order to horizontally flush-mount the TSS-CENTER4000 in a wall with standard 16" spacing between the studs, some modification to that area of the wall will be necessary.This type of installation will require a professional licensed contractor to install horizontal braces that comply with the customer’s local building codes.
INFP1614tss4000FMK-OM 10/29/04 11:39 AM Page 4 Step Three After you have found the correct placement on the wall for the speaker, use the template provided to draw the exact-sized hole required. Make sure to use a level when positioning the template to ensure that your installation is level.Then cut out the drywall to create the hole. Wall NOTE: The hole for the speaker should be 22-1/2" x 4-3/8." Template Screw Holes Step Four Place the mounting blocks inside the hole at either end.
INFP1614tss4000FMK-OM 10/29/04 11:39 AM Page 5 Step Five Attach speaker wires as described in the speaker’s owner’s manual and, using four #8 x 1-1/8" pan-head wood screws provided, screw the speaker assembly into place, making sure that the screws anchor themselves into the mounting blocks behind the drywall. (4) #8 x 1-1/8" Pan-Head Wood Screws Step Six Apply the sealing strips to either side of the speaker to cover the remaining openings of the cutout in the drywall.
INFP1614tss4000FMK-OM 10/29/04 11:39 AM Page 6 Step Seven Remove the paper cover from the gasket on the speaker-facing side of the frame. Place the frame over the in-wall assembly and snap it into place.
INFP1614tss4000FMK-OM 10/29/04 11:39 AM Page 7 Satellite Installation Exploded View For satellite installation, repeat the steps but cut the hole in a vertical direction, perpendicular to the floor.
INFP1614tss4000FMK-OM 10/29/04 11:39 AM Page 8 © 2004 Harman International Industries, Incorporated Infinity Systems, 250 Crossways Park Drive, Woodbury, NY 11797 USA 516.674.4INF (USA only) www.infinitysystems.com Infinity is a registered trademark, and Total Solutions is a trademark, of Harman International Industries, Incorporated. Part No. 400-OMINKIT 10/04 Infinity continually strives to update and improve existing products, as well as create new ones.
