User's Manual

19
11th Guiyang Street, YEDA,
Yantai 264006, P.R. China
[phone]
 Turn the controller (4) to select the zeroing distance according to the
distance set for the target;
 Press the controller (4) to confirm the zeroing distance, and open the
zeroing distance submenu, including two options, that is Zeroing and
Zeroing Distance.
Zeroing
 If the preset zeroing distance is consistent with that
displayed on the device, you can perform zeroing directly
following the steps as below:
 Turn the controller (4) to select Zeroing ;
 Press the controller (4) to go to the Zeroing interface;
 The X and Y coordinates of the reticle are displayed on the
top left corner of the screen;
 Aim the reticle center of the scope at the bull's eye at the
target distance and shoot, and then observe the position of
the actual point of impact;
 Keep the aiming position still, and press and hold the
controller (4) and the power button (5) at the same time
to freeze the picture. Meanwhile, the freezing icon is
displayed on the screen;
 Turn the controller (4) to move the reticle position until
the reticle center coincides with the position of the point of
impact. Release the screen freeze and shoot again. Adjust
the reticle center position based on the position of the point
of impact, until the reticle center aims at the position of the