User's Manual

23
11th Guiyang Street, YEDA,
Yantai 264006, P.R. China
[phone]
downward; turn the controller (4) counterclockwise to move the
indication box upward;
-Center: Press the power button (5) to center the indication box on the
screen.
Figure n. Laser Calibration
Pixel Defect
Correction
When using the scope, you may see pixel defects, such as visible light spots or
dark spots with stable brightness. To address this problem, use the Pixel Defect
Correction function to remove the pixel defects.
 Turn the controller (4) to select Pixel Defect Correction;
 Press the controller to go to the Pixel Defect Correction interface. A small
cross cursor appears in the center of the screen and the PIP function is
automatically enabled, which is displayed in the lower left corner of the
screen by default;
 The right side of the PIP window shows the pointer moving direction:
X-axis, Y-axis, and scale of pixel defect correction;
 Press the controller (4) to switch between the X-axis and the Y-axis;
 Turn the controller (4) to move along the direction selected, turn it
clockwise to move the cursor rightward or downward, or turn it
anticlockwise to move the cursor leftward or upward;
 Press the controller again to save the movement settings in this direction
and switch to the other axis;
 You can repeat the preceding steps to change the cursor location until it
reaches the position of the pixel defect;
 When the cursor moves to the position of the pixel defect, press the power