User's Manual

31
11th Guiyang Street, YEDA,
Yantai 264006, P.R. China
[phone]
 When using the scope for the first time, press and hold the controller (4) and power
button (5) for more than 8s to enable the hidden reticle and zeroing functions;
 Select a target at a certain distance, such as 100m and 200m;
 Adjust the scope according to the operating instructions as described in Power-on and
Settings in Chapter VII;
 Select the zeroing profile (refer to Zeroing Profile in Chapter XIII. Main Menu);
 Press and hold the controller (4) to open the main menu, select the zeroing option, and
press the controller (4) to open the submenu of the zeroing function;
 According to the selected target distance, select or add the new zeroing distance (refer to
Zeroing > Zeroing Distance > Set Zeroing Distance in Chapter XIII. Main Menu);
 After setting the zeroing distance, press and hold the controller (4) to save the parameter.
Turn the controller (4) to select the zeroing function, and press the controller (4) to go to
the zeroing interface (refer to Zeroing > Zeroing Distance > Zeroing Interface in
Chapter XIII. Main Menu). The X and Y coordinates of the reticle are displayed in the
upper left corner of the screen;
 Aim and shoot at the target;
 Observe the position of the actual point of impact, and assume that the red mark × in the
figure on the right is the position of the point of impact (This mark is only for illustration.
It should actually be a bullet hole);
 If the point of impact and the aiming point (the center point of the reticle) do not match,
keep the aiming position still, and meanwhile, press and hold the controller (4) and power
button (5) for 2s to freeze the picture, and then a snow-like freezing icon appears on
the left of the display, as shown in Figure n;
 Turn the controller (4) to move the reticle,
turn it clockwise to move the cursor right or
down, and turn it anticlockwise to move the
cursor left or up;
 Press the controller (4) to switch between the
X-axis and Y-axis, and the position of the
cursor indicates the selected item, with the
icon turning blue;