User's Manual

7
11th Guiyang Street, YEDA,
Yantai 264006, P.R. China
[phone]
VII. Mounting and Usage
Fixed mounting
WARNING: The lens of the thermal imaging scope must not be pointed at any sources of
intense radiation energy, such as laser-emitting devices or the sun. This may damage the
electronic components in the device. Damage caused by failure to comply with the operating
manual is not covered under warranty.
To ensure aiming accuracy, please fix TUBE TL35 SE at a proper position on the weapon.
 TUBE TL35 SE needs to be fixed with an adapter clamp, such as a simple Picatinny rail
clamp provided in the package. TUBE TL35 SE is designed with a 25.4mm diameter pipe
and can be used with a standard clamp for 25.4mm diameter pipes. Proper tools can be used
to mount TUBE TL35 SE according to the supplier's installation suggestions and steps;
 The mounting position of TUBE TL35 SE should be adjusted according to the distance
between the eye and eyepiece (eye relief) as specified in the specifications and the sense of
use and comfort. If you fail to follow this suggestion, the eyepiece may hurt the shooter
during the shooting;
 It is recommended to mount the scope as low as possible, but keep it away from the barrel
or other devices;
 It is recommended to use a torque wrench to tighten the screws of the mounting clamp, so
as to avoid damaging the scope body due to being over-tightened, and the recommended
torque shall not exceed 2.5Nm;
 When the scope is used for hunting, please carry out the zeroing operation first according to
the instructions as specified in Chapter IX Zeroing in this manual;
 When using the scope at night or in a dark environment, it is recommended to use an
eyeshade to avoid being found.
Power-on and Settings
 Remove the lens cap (7);
 Press and hold the power button(5) for 2s to start the device, and wait for several seconds