Operating Manual

- 31 -- 30 -
InfiRay Outdoor • Tube TD50L • Operating Manual InfiRay Outdoor • Tube TD50L • Operating Manual
Press the rotary encoder (7) to activate the
zeroing distance reset function, and then two
small triangle symbols are displayed above and
below the number .
Rotate the rotary encoder (7) to set the number
value of the current position from 0 to 9.
Press the rotary encoder (7) to switch among the
positions of hundred, ten and one digits.
After setting, press and hold the encoder (7) to
save the setting and exit. The cursor returns to the
zeroing option, and the zeroing distance changes
accordingly.
Besides, the status bar
updates to the new
zeroing distance
synchronously.
Standby-Set the standby status and time
Press and hold the rotary encoder (7) to enter the
main menu.
Rotate the rotary encoder (7) to select the
Standby option.
Press the rotary encoder (7) briefly to enter the
Standby submenu.
Rotate the rotary encoder (7) to select one option
from 10min, 20min,
30min and off.
Press the rotary
encoder (7) to confirm
the selection, and then
the selected option is
displayed on the top status bar.
If off is selected, the standby function is disabled.
When the device is in the following status, the
standby mode is activated automatically: up > 70° or
down > 70°, and left >30° or right > 30°
When the device is in the shooting status (horizontally
positioned), the standby mode is disabled.
-
-
Note
Settings
This function is used to set the date, time, language,
measurement unit, status auto hiding, factory reset,
and device information query.
Press and hold the rotary encoder (7) to enter the
main menu.
Rotate the rotary encoder (7) to select the
Settings option.
Press the rotary
encoder (7) to enter
the submenu of the
settings. This menu
item allows you to
configure the
following settings.
Date-Setting the system date
In the Settings submenu, rotate the rotary
encoder (7) to select the Date option.
Press the rotary encoder (7) briefly to activate the
date reset function accompanied by two triangle
This function is used to automatically hide the GUI
information on the interface other than the reticle, so to
make the image unobtrusive.
Rotate the rotary encoder (7) to select Settings
option in the main menu.
Press the rotary encoder (7) to enter the Settings
submenu, and rotate the rotary encoder (7) to select
Status Auto Hiding option.
Press the rotary encoder (7) to enter the submenu of
Status Auto Hiding option and then select On or Off
by rotating the rotary encoder (7).
After the status auto hiding is enabled, all GUI icons
including the status bar will be automatically hidden
and only the image and reticle are displayed if there is
no operation within 8s.
The GUI information will be displayed again with the
press of any button.
Only after the GUI is displayed, the button and menu
can be manipulated.