Operating Manual

Motion Sensor
Turn the motion sensor on/off
● Press and hold the M (7) button to enter the main menu.
● Press the Up (6) / Down (8) button to select the Motion Sensor option.
● Press the M (7) button to turn the gravity sensor on/off.
● After the motion sensor is enabled, its functions will be displayed on both sides of the
screen.
● The curved ruler on the left represents the tilt angle and the vertical ruler on the right represents the pitch angle.
Status Light
Turn the Status light on/off
● Press and hold down the M (7) button to enter the main menu.
● Press the Up (6) / Down (8) button to select the Status Light option.
● Press the M (7) button to turn the status light function on/off.
● When the status light is on, the status light will show steady green during normal operation, and the status light will blink during
standby.
Pixels Defect
Correction
Correcting the defective pixels
When using the thermal camera, you may see defective pixels, such as visible light spots or dark spots with stable brightness. To
address this problem, use the defective pixel correction function to remove the defective
pixels.
● Press and hold down the M (7) button to enter the main menu.
● Press the Up (6) / Down (8) button to select the Pixels Defect Correction option.
● Press the M (7) button to enter the defective pixel correction interface. The PIP function
is automatically turned on, and displayed on the lower-left corner by default.