Quick Start Guide

4
Turn on computer or other source
You may need to press a specifi c key combination to
activate your laptop's external video port. On most laptops,
hold down the FN key while pressing a key labeled CRT/LCD,
LCD/VGA, a monitor icon , or similar. Key combos for
popular models:
Apple F7 HP/Compaq Fn+F4 or Fn+F6 Sony Fn+F7
Dell Fn+F8 IBM ThinkPad Fn+F7 Toshiba Fn+F5
Fujitsu Fn+F10
Complete laptop activation chart at www.infocus.com/support
Wait for the lamp to warm up
After a few seconds, the power light will stop blinking, and
the other buttons on the keypad will light up. It can take a
minute for the lamp to reach full brightness.
Turn on projector and source
Connect the power cord to the
projector and to an electrical outlet
The power light on the projector will light amber.
Important:
If there is still no video, restart your
computer (fi rst make sure it's connected to the
projector and the projector is turned on).
USB
computer in
HDMI
video 1
video 2
audio out
audio in
5-10
Warning:
Do not look directly into the lens
when the projector is turned on.
sec.
source
1
Remove the lens cap
Turn on the projector
Touch the power light (or press power on the remote).
The power light will start blinking green.
Change source if needed
If needed, press source (on the projector or remote) to view
the source. You may have to press it more than once.
2
3
4
5
6