Operation Manual

47
SCREEN menu
Item Description
SOURCE NAME
(Continued)
(6) The current name will display on the rst
line. Use the ▲/▼/◄/► buttons and
the SELECT button to select and enter
characters. To erase 1 character at a
time, press the ◄ and SOURCE button
simultaneously. You can also move
the cursor to DELETE or ALL CLEAR
and press the SELECT button to erase
a single character or all characters.
The name can be a maximum of 16
characters.
(7) To change an existing character, press the ▲ button to move
the cursor to the rst line, and use the ◄/► buttons to move the
cursor onto the character to be changed.
After pressing the SELECT button, the character is selected.
Then, follow the same procedure as described in step (6) above.
(8) To nish entering text, move the cursor to OK on the dialog and
press the ►, SELECT button. To revert to the previous name
without saving changes, move the cursor to CANCEL and press
the ◄, SELECT button.
RULED LINES
Using the ▲/▼ cursor buttons switches the pattern screen mode.
Press the ► cursor (or the SELECT) button to display the selected
pattern, and press the ◄ cursor button to close the displayed
screen.
TEST PATTERN
ó
STACK
ó
MAP2
ó
MAP1
ó
CIRCLE ON
BLACK
ó
CIRCLE ON WHITE
ó
GRID ON BLACK
ó
GRID ON
WHITE
ó
LINES ON BLACK
ó
LINES ON WHITE
If CUSTOM KEY is set to RULED LINES, then the last selected
pattern will be displayed when the CUSTOM KEY on the remote is
pressed (

51).
(continued on next page)