Operation Manual
20
In a normal state
The Status Monitor displays the state of the projector
in three lines.
: Displays the projector condition. While the
lamp is on, the selected port is displayed.
Displayed conditions are:
STANDBY: The projector is in standby mode.
WARM UP: The projector is warming up.
SEARCHING: The projector is searching an input signal.
COOL DOWN: The projector is cooling down.
: While the lamp is on, the detected input signal condition is
displayed. Otherwise, the projector's serial number is displayed.
Displayed conditions are:
SYNC OUT: Detected input signal is out of specied range.
NO SIGNAL: There is no input signal.
CONNECTED: The LAN or USB TYPE B port is selected, the projector is
connected to the network (or the computer) and an image is being transferred
to the projector.
HOLD: The LAN port is selected and the projector is connected to the network
but no image is transferred.
NOT CONNECTED: The LAN or USB TYPE B port is selected, but the
projector is not connected to the network or the computer.
Status Monitor
<Only for IN5142, IN5144, IN5144a and IN5145>
Status Monitor
Displaying the projector condition
The Status Monitor is the LCD window on the rear
panel of the IN5142, IN5144, IN5144a and IN5145.
The Status Monitor displays the projector's present
condition, including errors, setup information and error
history.
<IN5142, IN5144, IN5144a and IN5145 only>
If no buttons are being operated, the Status Monitor will display the projector's
condition as per below.
Status Monitor
1st line
2nd line
• If the STANDBY MODE item of SETUP menu is set to SAVING (56),
the Status Monitor displays nothing while the projector is in standby mode.
• When INSTALLATION in the SETUP menu is set to FRONT / CEILING or REAR /
CEILING, the Status Monitor contents are displayed upside down (55).
NOTE
(continued on next page)
example
9
2 3 ° C
#
1 2 3 4 5 6 7 8 0 A B
S T A N D B Y