Operation Manual

65
OPTION menu
OPTION menu
From the OPTION menu, you can perform the items
shown in the table below.
Select an item using the ▲/▼ cursor buttons, and
press the ► cursor button or the ENTER button to
perform this item, except items LAMP TIME and
FILTER TIME. Then follow the instructions below.
Item Description
SOURCE SKIP
Ports can be ignored by the AUTO SEARCH function (

below
)
and when using buttons on the control panel.
(1) Choose a picture input port using the
▲/▼ buttons.
(2) Using the ◄/►buttons turns the
SOURCE SKIP function on/off.
NORMAL
ó
SKIP
The port that is set to SKIP will be ignored.
• You cannot SKIP all of the ports simultaneously.
• This setting is not valid when in the PbyP mode (

37
).
AUTO SEARCH
Using the ▲/▼ buttons turns the automatic signal search function
on/off.
ON
ó
OFF
When ON is selected, the projector automatically cycles through
input ports in the following order looking for an active source. The
search is started from the current port. When an input is found, the
projector will stop searching and display the image.
COMPUTER IN1
ð
COMPUTER IN2
ð
LAN
ð
USB TYPE A
 
VIDEO USB TYPE B
 
S-VIDEO

COMPONENT

HDMI 2

HDMI 1
• It may take several seconds to project the images from the
USB TYPE B
port.
AUTO
KEYSTONE
Using the ▲/▼ buttons turns the automatic keystone function on/
off.
ON
ó
OFF
ON: Automatic keystone distortion correction will be performed
whenever the projector slant changes.
OFF: Disables automatic keystone correction. Execute the AUTO
KEYSTONE (EXECUTE) in the SETUP menu for automatic
keystone distortion correction.
• When the projector is suspended from the ceiling, turn this feature
OFF since it will not operate correctly.
• This function is unavailable when the Transition Detector is on
(

90
).
(continued on next page)