Operation Manual

27
Operating
Most of operations are effective for the main area
only. Also the audio input signal paired with the
picture input signal for the main area is assigned
as the audio output signal. The main area can be
changed using the cursor buttons ◄/► when the
setting information is on the screen.
PbyP (Picture by Picture)
The PbyP is a function to display two different picture signals on a screen that is
split in two areas for each signal. Some of functions can be used with the same
operation as it for the normal mode (not in the PbyP mode). There are some
operations available only in the PbyP mode.
The setting information is displayed for several
seconds when the PbyP function is started. It shows
the input signal information for each area. There also
will be a yellow frame on the area where most of operations are effective. The
information can be displayed using the cursor buttons ▲/▼/◄/► when the setting
information is not on the screen.
Press the PbyP button on the
remote control to start the PbyP
function. To quit the PbyP mode,
press the button again.
Press the COMPUTER, VIDEO or DIGITAL button
while in the PbyP mode, the menu to select the
input signal will be appeared. Choose a signal using
the cursor buttons ▲/▼. If you want to change the signal in the
sub area, switch the main area using the cursor buttons ◄/►
rst. Displaying the same signal on the areas is not allowed.
For other combinations of the input signal, refer to the right
table. Any combinations marked with X can not be selected.
<signal combination>
Press the MY BUTTON assigned the PbyP SWAP
(49). The position of the area is exchanged without
any setting change.
Starting the PbyP
Changing the main area
Showing the setting information
Changing the picture input signal
Using the PbyP SWAP function
normal mode
PbyP
mode
•For some signals, it may not be displayed correctly in the PbyP mode,
even if it can be displayed properly in the normal mode.
NOTE
main area
sub area
main area
Sub
Main
COMPUTER IN1 COMPUTER IN2
BNC
HDMI
DVI-D
Component
Scart RGB
S-Video
Video 1 Video 2
COMPUTER IN1 0 0 0 0 0 0 0 0 0
COMPUTER IN2 0 0 0 0 0 0 0 0 0
BNC 0 0 0 0 0 0 0 0 0
HDMI 0 0 0 X 0 X X X X
DVI-D 0 0 0 X 0 X X X X
Component 0 0 0 0 0 0 0 0
Scart RGB 0 0 0 X X X X X
S-Video 0 0 0 X X 0 X X X
Video 1 0 0 0 X X 0 X X X
Video 2 0 0 0 X X 0 X X X
BLANK LASER
FREEZE
LASER
INDICATOR
DIGITAL
STANDBY/ON COMPUTER
LENS SHIFT
KEYSTONE
ID 3
ID 4
ID 2
ID 1
VIDEO
AUTO
ASPECT
RESET
MENU
MAGNIFY
ON
OFF
3
4
ENTER
FOCUS
+
-
POSITION
PbyP
ZOOM
+
-
1
2
MY BUTTON
MY SOURCE
SHUTTER
setting information