User's Guide Part 1

3
Important Operating Considerations for Safety
• Refer to this guide for proper startup and shutdown procedures.
• Follow all warnings and cautions in this manual and on the projector.
• Do not look into the lens while the projector is being used.
• Place the projector in a horizontal position no greater than 8 degrees off
ax
is.
• Locate the projector in a well-ventilated area without any obstructions
to intake or exhaust vents. Do not place the projector on a tablecloth or
other soft covering that may block the vents.
• Do not set up the projector in humid or dusty places or in places where
t
he projector may come into contact with smoke or steam.
• Locate the projector at least 4' (1.2m) away from any heating or cooling
ve
nts.
• Use only the power cord provided. A surge-protected power strip is
recommended.
• Do not overload wall outlets.
• When disconnecting the power cord, hold the plug, not the cord.
• Use only InFocus-approved ceiling mounts. Warning: To prevent eye
injury if the projector is ceiling mounted, wear protective eyewear
before opening lamp door. A warning sticker is included with the user
documentation. Place this sticker on the lamp door if the projector is
mounted on the ceiling.
• The projector must be installed by a qualified professional in order to
en
sure proper operation and reduce the risk of hazards or injury. It is
not recommended you install the projector yourself.
• Refer all service to qualified service personnel. Servicing your own
pr
ojector can be dangerous to you and will void the warranty.
• The projector remote control uses batteries. Make sure the batteries
polarity (+/-) is aligned correctly. Dispose of used batteries in
accordance with local disposal laws.
• Wash hands after handling the cables supplied with this product.
• Hg-Lamp contains mercury. Manage in accordance with local disposal
la
ws. See www.lamprecycle.org.
• In the unlikely event of a lamp rupture, particles may exit through the
pr
ojector vents. Keep people, food, and drinks out of the "keep out"
area under and around the projector, as indicated by the "X" areas
below.Only genuine InFocus lamps are tested for use in this projector.
InFocus is not liable for the performance, safety or certification of any
other lamps. The use of other lamps violates the projector warranty and
voids all certification marks on this projector. vents. Do not place the
projector on a tablecloth or other soft covering that may block vents.
Follow these instructions to help ensure image quality and lamp life over
t
he life of the projector. Failure to follow these instructions may affect the
warranty. For complete details of the warranty, see the Warranty Booklet.
5
’ /1.5m
8
’
/2.4m
3
’
/1m
2
’
/0.6m