INSTALLATION INSTRUCTIONS Instrucciones de instalación Installationsanleitung Instruções de Instalação Istruzioni di installazione Installatie-instructies Instructions d´installation Single Stud Short Throw Wall Mount Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description PRJ-WALLKIT-11
PRJ-WALLKIT-11 Installation Instructions DISCLAIMER InFocus and its affiliated corporations and subsidiaries (collectively "InFocus"), intend to make this manual accurate and complete. However, InFocus makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product.
Installation Instructions PRJ-WALLKIT-11 LEGEND Tighten Fastener Pencil Mark Apretar elemento de fijación Marcar con lápiz Befestigungsteil festziehen Stiftmarkierung Apertar fixador Marcar com lápis Serrare il fissaggio Segno a matita Bevestiging vastdraaien Potloodmerkteken Serrez les fixations Marquage au crayon Loosen Fastener Drill Hole Aflojar elemento de fijación Perforar Befestigungsteil lösen Bohrloch Desapertar fixador Fazer furo Allentare il fissaggio Praticare un foro B
PRJ-WALLKIT-11 Installation Instructions TOOLS REQUIRED FOR INSTALLATION 5/32" (security) [included] #2 1/2" (12.7mm) 7/16" (11.2mm) 1/2" (12.7mm) 3/8" (9.5mm) 7/32" (5.
Installation Instructions PRJ-WALLKIT-11 Site Requirements WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! The figure below identifies the minimum requirements for installation of display mounts onto a steel stud structure. If the structure or its components do not meet these requirements contact the mount manufacturer for specific instructions before attempting installation.
PRJ-WALLKIT-11 Installation Instructions ASSEMBLY AND INSTALLATION The single stud short throw wall mount can be mounted to concrete, concrete block, 2" x 4" wood studs or steel studs. (Y) x 4 4 Installing Mounting Bracket (Q) x 4 WARNING: ELECTRICAL SHOCK HAZARD! CUTTING OR DRILLING INTO ELECTRICAL CORDS OR CABLES CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY! ALWAYS make certain area behind mounting surface is free of electrical wires and cables before cutting, drilling, or installing fasteners.
Installation Instructions 5. PRJ-WALLKIT-11 Install three 5/16 x 2-1/2" hex head lag screws (P) through three 5/16" washers (Q), inner holes of wall bracket (B) and into drilled holes. (See Figure 4) 5. Hold metal channel on anchor (H) flat alongside plastic straps and slide channel through hole. (See Figure 6) Drywall Plastic Straps 5 5 (P) x 3 (Q) x 3 (H) x 3 Figure 6 6.
PRJ-WALLKIT-11 Installation Instructions 10. Place wall bracket (B) over anchors and align mounting holes in display mount with holes in anchors. (See Figure 9) 11. Insert 1/4-20 x 1-3/4" Phillips pan head screws (F) through 1/4" washer (G), corresponding mounting hole on wall bracket and into anchor (H) and tighten until flush against mount. DO NOT overtighten! (See Figure 9) 1 (B) Upper plate 1 12. Repeat Steps 10 through 11 for remaining 2 mounting holes.
Installation Instructions PRJ-WALLKIT-11 Projector Installation Installing Mount Covers 1. Raise lower cover (D) up to wall mount assembly. (See Figure 12) WARNING: Exceeding the weight capacity can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the combined weight of all components attached to the short throw projector mounts up to (and including) the projector does not exceed 25 lbs (11.34 kg) for the PRJ-WALLKIT-11.
PRJ-WALLKIT-11 Installation Instructions Projector Installation to Mount 7 Lock WARNING: IMPROPER INSTALLATION CAN LEAD TO 6 Locking lever PROJECTOR FALLING RESULTING IN SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT. DO NOT substitute hardware. Use only the hardware provided by the manufacturer. 1. Secure interface bracket (AA) to top of InFocus projector (not included) using hardware and instructions included with the interface bracket. 2. Orient projector with attached interface bracket as shown.
Installation Instructions PRJ-WALLKIT-11 Pitch Adjustment NOTE: Pitch can be adjusted using the projector mount or the pitch of the entire arm can be adjusted. See Pitch Adjustment - Entire Arm section for details. 1. Loosen Pitch adjustment locking screw using a #2 Phillips screwdriver. (See Figure 19) 2. Turn Pitch micro-adjustment screw right or left using a #2 Phillips screwdriver until image is properly aligned on target. (See Figure 19) 3.
PRJ-WALLKIT-11 Installation Instructions Pitch Adjustment - Entire Arm 1. Loosen two 5/16-18 x 1/2" hex head screws (T) (one on each side of wall bracket). (See Figure 22) 2. Loosen two bolts (one on each side of pitch adjustment screw). (See Figure 22) 3. Adjust pitch adjustment screw until mount is at desired pitch level. • • (projector not shown) Turn clockwise to raise mounting level. Turn counterclockwise to lower mounting level. (See Figure 22) 4.
Installation Instructions 3. PRJ-WALLKIT-11 (Optional) Cables can be tied to inside of projector’s front cover using cable ties (not included). Route cables near front cover and wrap cable tie through slots on front cover and around cables. (See Figure 25) Extension Adjustment 1. Loosen two bolts holding stop bracket in place on underside of short throw projector mount. (See Figure 27) 2. Adjust mount to desired extension length. (See Figure 27) 3.
PRJ-WALLKIT-11 3. Installation Instructions Remove two bolts holding stop bracket in place on underside of short throw projector mount. (See Figure 29) Adapter plate Stop bracket 3 x2 4. x 4 (one at a time) 6 Figure 29 Install two 1/4-20 x 1/2" button head security screws (K) through holes in stop bracket and into holes in sliding nuts. (See Figure 30) Sliding nuts Figure 31 7.
Installation Instructions Visit the InFocus support site at www.infocus.
PRJ-WALLKIT-11 Installation Instructions InFocus Corporation 13190 SW 68th Parkway, Ste 200 Portland, OR 97223 8800-002228 Rev00 ©2012 InFocus Corporation www.infocus.