Installation instructions

SP-WALLKIT-02 Installation Instructions
10 Visit the InFocus support site at www.infocus.com/support
Projector Installation to Mount
WARNING: IMPROPER INSTALLATION CAN LEAD TO
PROJECTOR FALLING RESULTING IN SERIOUS
PERSONAL INJURY OR DAMAGE TO EQUIPMENT. DO
NOT substitute hardware. Use only the hardware provided by
the manufacturer.
1. Secure interface bracket (X) to top of InFocus projector
using three M4x12mm Phillips pan machine screws (Z) and
three M4 washers (AA). (See Figure 17)
Figure 17
2. Orient projector with interface bracket as shown in Figure
17.
3. Lift projector so that screws with thumb nuts are aligned
with mounting slots in mount base.
4. Slide projector with mounting bracket onto mounting slots in
mount base until screws are seated against the back of
mounting slots. (See Figures 17 and 18)
Figure 18
WARNING: IMPROPER INSTALLATION CAN LEAD TO
PROJECTOR FALLING RESULTING IN SERIOUS
PERSONAL INJURY OR DAMAGE TO EQUIPMENT. Make
certain mounting slots in mount base slide under thumb
screws and that screws are seated in the back of slots.
5. Verify mounting screws are properly seated in mounting
slots in mount base. (See Figure 19)
6. Move locking lever to "locked" position. (See Figure 19)
7. Insert key into lock and turn to secure projector to mount.
(See Figure 17)
Figure 19
Projector Mount Adjustments
Yaw Adjustment
1. Loosen yaw adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 20)
2. Turn Yaw micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
(See Figure 20)
3. Tighten Yaw adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 20)
Figure 20
(X)
(Z) x 3
1
InFocus projector
3
4
(Y)
(X)
6
7
(reverse view)
2
1
3
2