Installation instructions

Installation Instructions SP-WALLKIT-02

Visit the InFocus support site at www.infocus.com/support 11

Pitch Adjustment

NOTE: Pitch can be adjusted using the projector mount or the

pitch of the entire arm can be adjusted. See "Pitch

Adjustment - Entire Arm Section for details.

1. Loosen Pitch adjustment locking screw using a #2 Phillips

screwdriver. (See Figure 21)

2. Turn Pitch micro-adjustment screw right or left using a #2

Phillips screwdriver until image is properly aligned on target.

(See Figure 21)

3. Tighten Pitch adjustment locking screw using a #2 Phillips

screwdriver. (See Figure 21)

Figure 21

Roll Adjustment

1. Loosen ROLL adjustment locking screw using a #2 Phillips

screwdriver. (See Figure 22)

2. Turn ROLL micro-adjustment screw right or left using a #2

Phillips screwdriver until image is properly aligned on target.

(See Figure 22)

3. Tighten ROLL adjustment locking screw using a #2 Phillips

screwdriver. (See Figure 22)

Figure 22

Cable Management (Optional)

1. Remove two screws #8-32 x 1/2" Phillips pan machine

screws (F) to release mount cover. (See Figure 23)

2. Slide mount cover away from wall mount. (See Figure 23)

Figure 23

NOTE: In most cases, cable management covers will NOT

need to be removed in order to route cables from

projector to the wall mount. But for some thick cables,

removing the covers may be necessary.

3. Remove cable management covers (if necessary) from

short throw projector arm. (See Figure 24)

Figure 24

NOTE: Cables may be routed from below and up wall bracket

channel, or from above and down behind and into wall

mount.

• Routing Cables from Below (Steps 4 and 5)

4. Open cable clips along bottom edge of wall bracket cross

bracket (See Figure 25)

(underside)

(F) x 2

(bottom view)

small cable cover

large cable cover

projector