Installation instructions

Installation Instructions SP-WALLKIT-02
Visit the InFocus support site at www.infocus.com/support 13
8. (Optional) Cables can be tied to inside of projector’s front
cover using cable ties (not included). Route cables near
front cover and wrap cable tie through slots on front cover
and around cables. (See Figure 29)
Figure 29
9. Replace removed cable management covers (if necessary).
Insert one side of cover into groove and press down firmly
on the cover on the other side until it snaps into the other
groove. (See Figure 30)
Figure 30
10. Slide outer cover of mount (A) back against mounting
bracket. (See Figure 31)
Figure 31
11. Reinstall two #8-32 x 1/2" Phillips pan machine screws (F)
through holes on sides of outer cover. (See Figure 32)
Figure 32
cable tie (not included)
route through slots and
around cables
8
9
10
(F) x 2
11