Installation instructions

SP-WALLKIT-02 Installation Instructions
14 Visit the InFocus support site at www.infocus.com/support
Installation of Wall Bracket Covers
NOTE: If security screws are going to be used, use the security
screws (V) to install wall bracket covers. See Security
Screw Installation section for details.
1. Place wall bracket top covers (C) over top of each wall
bracket arm. (See Figure 33)
Figure 33
2. Secure wall bracket top covers (C) to wall bracket arms by
installing four #8-32 x 1/2" Phillips pan machine screws (F)
through holes in covers and wall bracket. (See Figure 34)
3. Place wall bracket bottom covers (D) over bottom of each
wall bracket arm. (See Figure 33)
4. Secure wall bracket bottom covers (D) to wall bracket arms
by installing four #8-32 x 1/2" Phillips pan machine screws
(F) through holes in covers and wall bracket. (See Figure 34)
Figure 34
Adjustments
Bracket Width Adjustment
1. Loosen two flat head cap screws on wall bracket. (See
Figure 35)
2. Slide wall brackets to corresponding width of studs. (See
Figure 35)
3. Tighten two flat head cap screws on wall bracket. (See
Figure 35)
Figure 35
Pitch Adjustment - Entire Arm
1. Remove two #8-32 x 1/2" Phillips pan machine screws (F)
to free outer cover from mounting bracket. (See Figure 36)
Figure 36
2. Slide outer cover of mount (A) away from mounting bracket
to expose pitch adjustment screw. (See Figure 37)
(C) x 2
(D) x 2
3
1
projector arm not shown
for display purposes
2
(F) x 4
4
(F) x 4
projector arm not shown
for display purposes
1 3
2
2
(F) x 2
1