Installation instructions

Installation Instructions SP-WALLKIT-02
Visit the InFocus support site at www.infocus.com/support 15
Figure 37
3. Loosen two 1/4-20 x 5/8" hex head cap screws (E) on
underside of mounting bracket. (See Figure 38)
Figure 38
4. Loosen two bolts on either side of pitch adjustment screw.
(See Figure 39)
5. Adjust pitch adjustment screw until mount is at desired pitch
level. Turn clockwise to raise mounting level or turn
counterclockwise to lower mounting level. (See Figure 39)
6. Tighten two bolts on either side of pitch adjustment screw.
(See Figure 39)
7. Tighten two 1/4-20 x 5/8" screws (E) on underside of
mounting bracket. (See Figure 39)
Figure 39
8. Slide outer cover of mount (A) back against mounting
bracket. (See Figure 39)
9. Reinstall two #8-32 x 1/2" Phillips pan machine screws (F)
through holes on sides of outer cover. (See Figure 40)
Figure 40
2
pitch adjustment screw
(bottom view)
3
(E) x 2
7
4 6
or
5
8
(F) x 2
9