Installation instructions

SP-WALLKIT-02 Installation Instructions
16 Visit the InFocus support site at www.infocus.com/support
Extension Adjustment
1. Loosen two bolts holding stop bracket in place on underside
of short throw projector mount. (See Figure 41)
2. Adjust mount to desired extension length. (See Figure 37)
3. Tighten two bolts holding stop bracket to secure mount in
desired position. (See Figure 41)
Figure 41
Lateral Shift Adjustment
1. Remove two #8-32 x 1/2" Phillips pan machine screws (F)
to free outer cover from mounting bracket. (See Figure 42)
Figure 42
2. Slide outer cover of mount (A) away from mounting bracket.
(See Figure 43)
Figure 43
3. Loosen two 1/4-20 x 5/8" hex head cap screws (E) on
underside of mounting bracket. (See Figure 44)
4. Adjust projector arm laterally to desired position. (See
Figure 44)
5. Tighten two 1/4-20 x 5/8" hex head cap screws loosened in
Step 3. (See Figure 44)
6. Slide outer cover of mount (A) back against mounting
bracket. (See Figure 43)
7. Replace two #8-32 x 1/2" Phillips pan machine screws
removed in Step 1. (See Figure 42)
Figure 44
(bottom view)
1 3
2
(F) x 2
1
7
6
2
(bottom view)
3
(E) x 2
5
4