Installation instructions

SP-WALLKIT-02 Installation Instructions
18 Visit the InFocus support site at www.infocus.com/support
6. Install two 1/4-20 x 1/2" button head security screws (T)
through holes in stop bracket and into holes in sliding nuts.
(See Figure 49)
Figure 49
7. (Optional) Remove projector from short throw projector
mount according to projector interface instructions.
NOTE: It will be necessary to remove projector prior to install
four security screws to projector bracket. For ease of
installation, it is recommended to remove projector
prior to performing the following steps.
8. Remove one of four bolts from adapter plate. (See Figure
50)
Figure 50
9. Install one 1/4-20 x 3/4" button head security screw (U) into
hole vacated by removing bolt in Step 8 and into plastic
spacer. (See Figure 51)
10. Repeat Steps 8-9 for remaining three bolts one bolt at a
time.
WARNING: It is important to replace adapter plate bolts
ONE AT A TIME or adapter plate could fall from mount during
installation!
Figure 51
11. Reinstall projector to mount. Refer to Projector Installation
Section for details.
6
(T) x 2
stop bracket
sliding nuts
adapter plate
8
x 4 (one at a time)
plastic spacer
adapter plate
(U) x 4 (one at a time)
9