Installation instructions

Installation Instructions SP-WALLKIT-02
Visit the InFocus support site at www.infocus.com/support 7
Steel Studs
IMPORTANT ! : See Site Requirements section before
proceeding with Steel Studs installation to ensure
installation site meets requirements! The drywall must
have a minimum thickness of 1/2"!
1. Determine mounting location on wall. Use stud finder to
locate steel studs. For studs less than 16" apart, mounting
brackets will have to be adjusted. See Adjustments section
for details.
2. Draw a dotted line down the center of the studs to be used
for mounting.
3. Line up four holes on mounting bracket with center of studs
at desired mounting location. (See Figure 5)
4. Using mounting bracket as a template, mark four holes at
the inner four holes in bracket. (See Figure 5)
5. Drill four 1/2" holes at marked locations in wall. (See
Figure 5)
Figure 5
6. Hold metal channel on anchor (P) flat alongside plastic
straps and slide channel through hole. (See Figure 6)
Figure 6
7. Holding plastic straps on anchor (P), pull anchor away from
wall until channel rests flush behind wall making sure
anchor channel is positioned vertically on stud. (See
Figure 7)
8. Slide plastic cap on anchor (P) towards wall until flange of
cap is flush with wall. (See Figure 7)
Figure 7
9. Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 8)
10. Repeat steps 7 through 9 for each mounting hole.
Figure 8
11. Place wall bracket over anchors and align mounting holes
in display mount with holes in anchors. (See Figure 9)
12. Insert 1/4-20 x 1-3/4" Phillips pan head screws (N) through
1/4" washer (Q), corresponding mounting hole on wall
bracket and into anchor (P) and tighten until flush against
mount. DO NOT overtighten! (See Figure 9)
13. Repeat steps 11 through 12 for remaining 3 mounting holes.
WARNING: IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Overtightening of
mounting hardware can damage the steel studs. DO NOT
overtighten mounting hardware!
(front view)
(B)
steel studs
4
5
x 4
x 4
(P) x 4
Drywall
Plastic Straps
6
(P) x 4
Plastic Cap
Drywall
Anchor Metal Channel
SIDE VIEW
8
Steel Stud
Plastic Straps
Drywall
Anchor Metal Channel
Plastic Cap
SIDE VIEW
9
Steel Stud