Installation instructions

SP-WALLKIT-02 Installation Instructions
8 Visit the InFocus support site at www.infocus.com/support
Figure 9
Installation to Wall Bracket
1. Lift short throw projector arm (A) up to mounting bracket (B)
and hook top plate onto cross bracket on mounting bracket.
(See Figure 10)
Figure 10
2. Slide lower plate onto cross bracket on mounting bracket.
(See Figure 11)
Figure 11
3. Install two 1/4-20 x 5/8" hex head bolts (E) through holes on
short throw projector arm (A) and into sliding nuts on
mounting bracket (B). DO NOT TIGHTEN SCREWS AT
THIS POINT! (See Figure 12)
Figure 12
4. Loosen two bolts on either side of pitch adjustment screw.
(See Figure 13)
5. Adjust pitch adjustment screw until mount is at desired pitch
level. Turn clockwise to raise mounting level or turn
counterclockwise to lower mounting level. (See Figure 13)
6. Tighten two bolts on either side of pitch adjustment screw.
(See Figure 13)
Drywall
Anchor Metal Channel
(B)
SIDE VIEW
(N) x 4
12
Steel Stud
(Q) x 4
1
(A)
(B)
2
(A)
(B)
(bottom view)
(A)
(B)
3 (E) x 2