User's Manual

• 30 • • 31 •
HOW TO USE
Wash your hands carefully with warm water to increase the circulation of the
blood into the fingers.
Dry hands thoroughly until the finger to be pricked is completely dry. Please read
the following steps with corresponding illustrations to understand how to use the
lancing device.
1. Unscrew the tip of the lancing device by turning it
counter-clockwise while holding the base firmly.
2. With two fingers, pull out the lancet carrier and hold
it in place.
3. While holding the lancet carrier, insert a new sterile
lancet into the bottom of lancet carrier.
5. Put the tip of the lancing device back on and turn it
clockwise.
4. Twist the cap of the lancet off.
RECOMMENDED AVAILABLE LANCETS
Some general sterilized lancets are BD-Ultra Fine, Cleanlet Fine, E-Z Ject, G-P
Lite, Microlet, Monolet, One Touch, Soft Touch, Therasense, Ultra TLC and Unilet
GP.
Note: Some less known lancets may not work properly with the lancing device
due to their dimensions.
Please, contact your supplier to make sure you are using proper lancets.
6. Hold the tip firmly in one hand then pull out the
sliding barrel with the other hand. This will cock the
lancing device.
7. Place the lancing device in place. Hold the lancing
device firmly against the side of the finger, with the
cap resting on the finger. (The harder it is pressed
the deeper the puncture.) Press the release button
to take a sample.
8. Unscrew the tip of the lancing device by turning it
counter-clockwise.
9. Push the lancet ejector forward with the thumb and
simultaneously pull out the sliding barrel to dispose
of the used lancet in a proper biohazard container.
Click