User's Manual

• 36 • • 37 •
Test Procedure Test Procedure
Press mode ( ) button after a test strip is
inserted and confirm if the meter recognizes the
right test strip by checking out the corresponding
symbol on its display.
The meter displays the code number and the
testing symbols ( , , ) together.
In 5 seconds the meter automatically enters into
testing mode.
The symbol of blood is blinking.
Please apply the sample to the total cholesterol
test area of test strip until you hear beep sound.
Then, the symbol, disappears.
Please apply the sample to the HDL-cholesterol
test area of test strip until you hear beep sound.
Then, the symbol, disappears.
Please apply the sample to the triglyceride test
area of test strip until you hear beep sound.
Then, the symbol, disappears.
The meter displays , blinking in order,
which means it is under test.
Total cholesterol is displayed with 3 times of
buzzing sound.
In the case of LDL-cholesterol, if density of
triglyceride is over 350mg/dL, and/or TC, HDL,
TG measurement range are displayed as
Hi(above the measurement range) or Lo(below
the measurement rage, it cannot be measured.
In order to check each test item, please press up or down button. You can check
out each result of Total Cholesterol, HDL-Cholesterol and Triglyceride.
1. Lipid test - Test for multi items