ELD Series Installation Manual

Electric I&O Manual IM111116 RL:1 Nov 2016
INSTALLATION INSTRUCTIONS
SPECIFICATIONS
This heater must be permanently installed and hard wired by a licensed electrician in accordance with local
electrical codes. Assembly procedure must be performed with no electrical power to unit.
Step 1: Check UL/CUL/CE label on heater for proper voltage.
Step 2: Follow supplied wiring instructions. [See wiring instructions below]
Step 3: Heater must be mounted with reector angled down.
Step 4: All electrical connections must be in compliance with the National Electric Code [NEC] and local codes
for outdoor wiring.
Step 5: Use only wiring components UL/CUL/CE listed for outdoor use with IPX4 minimum rating.
3
WIRING INSTRUCTIONS
The heater is drilled and threaded for standard 1/2" conduit ttings. The installing electrician will need to provide
the appropriate rigid metallic, exible or liquid tight conduit for the installation location.
▪ Observe local electrical code regulations.
▪ Remove cover plate from junction box.
▪ Attach conduit.
▪ Use only copper wire suitable for 90°C.
▪ Replace cover plate.
TYPICAL WIRING OPTIONS
TYPICAL 120V
WIRING
FOR A SINGLE
POLE SWITCH
TYPICAL 240V
WIRING FOR
A TWO POLE
SWITCH
WIRING FOR OPTIONAL 120V/240V
CONTROLS
Connect power with exible
conduit or appropriate cord to
allow heater to be swiveled.
Junction Box on top of the heater has a gasket side access cover.
The Junction Box inlet hole is sized for
a standard ½" weather tight conduit
tting and has a locknut located on the
inside of the box for fastening.
GREEN GROUND
WIRE SCREW
HEATING ELEMENT
OFF
ON
OFF
ON
HEATER
TOP
P L1 L2
H2H1
HEATER
FOR 115V. PILOT
LIGHT IF USED
11/32" (0.9 CM) INSIDE NUT
SNUG TO CERAMIC
11/32" (0.9 CM) OUTSIDE NUT
REAR VIEW OF
CONTROLLER FOR
MAX. 15 AMP
LOAD ONLY
"TOP" MARKED ON
REAR OF CONTROL
MUST BE INSTALLED
IN AN UP POSITION
240 V.
240 V.
WHITE
BLACK 115 V.
MODEL WATTS LENGTH VOLTS/AMPS PHASE SHIP WGT.
ES-519 500 19.5" 120/4.2 Single 10
ES-719 750 19.5" 120/6.3 Single 10
ES-1033 1000 33" 120/8.3 Single 12
ES-1533 1500 33" 120/12.5 208/7 240/6.3 Single 12
ES-2039 2000 39" 208/10 240/8.3 277/7 480/4 Single 13
ES-2539 2500 39" 208/12 240/10.4 277/9 480/5 Single 13
ESD-3033 3000 33" 208/14 240/12.5 277/11 480/6 Single 13
ES-3061 3000 61.25" 208/14 240/12.5 277/11 480/6 Single 20
ESD-4039 4000 39" 208/19 240/16.7 277/14 480/8.3 Single 14
ES-4061 4000 61.25" 208/19 240/16.7 277/14 480/8.3 Single 20
ESD-5039 5000 39" 208/24 240/20.8 277/18 480/10.4 Single 14
ESD-6061 6000 61.25" 208/28.8 240/25 277/21.7 480/12.5 Single 21