Manualshelf

Installation Manual

ManualsBrandsInfratech ManualsOutdoor LivingC Series 33" Single Element Heater With 1500 Watt 240V 6.3 Amps
12345678
5
REPLACEMENT ELEMENT INSTALLATION (VISIT INFRATECH-USA.COM FOR VIDEO INSTRUCTIONS)
Disconnect the power at the breaker. Remove the grill by grasping it in the middle, flex grill up and lift it off. Unscrew
and remove both end reflectors. Unhook element clips at each end of the heater and remove nuts from end of element
to remove the existing quartz tube. Carefully install the new element. Remove one nut from end of the new element.
Install wire by sliding high temperature ring terminal onto element screw and replace nut. Use a thin 11/32" wrench to
hold inside nut. Nuts must make a tight connection. Close element clips over tube, reinstall end reflectors, then snap
protective grill back in place.
NOTE: Hold ceramic element firmly while
tightening nut to prevent damage to
element. Nut should be tightened snug.
A loose connection can cause the
element to short or fail prematurely.
SCAN FOR
VIDEO
INSTRUCTIONS
Need help? To order replacement
elements for your Infratech
heating system, please contact
us via phone or visit our website.
Consult the label on back of
heater for proper watts, voltage,
and replacement element part
number.
REPLACEMENT ELEMENTS (OTHER VOLTAGES ALSO AVAILABLE)
PART NUMBER ELEMENT NUMBER LENGTH WATTS VOLTS FITS
10-1020 E-7512 16-1/2" (0.4m) 750 120 C-7512
10-1050 E-1412 30" (0.8m) 1500 120 C-1512
10-1055 E-1424 30" (0.8m) 1500 240 C-1524/CD-3024
10-1085 E-2024 36" (0.9m) 2000 240 C-2024/CD-4024
10-2010 E-2524 36" (0.9m) 2500 240 C-2524/CD-5024
10-2030 E-3024 58" (1.5m) 3000 240 C-3024/CD-6024
10-2055 E-4024 58" (1.5m) 4000 240 C-4024
REPLACEMENT PARTS
PART NUMBER PART DESCRIPTION QUANTITY
13-1210 Single Element End Reflector (Set of 2) 1
13-1252 Dual Element End Reflector (Set of 2) 1
13-1207, 13-1208, 13-1209 C-Series Body Reflector – Fits 33" (0.8m), 39" (1.0m), 61-1/4" (1.6m) 1
13-1242, 13-1240, 13-1245 Grill Guard – Fits 33" (0.8m), 39" (1.0m), 61-1/4" (1.6m) 1
13-1232, 13-1230, 13-1235 Lead Wire Set – Fits 33" (0.8m), 39" (1.0m), 61-1/4" (1.6m)* 1
13-1250 SS Mounting Bracket (Set of 2) 1
* Note: Dual Element Heaters require 2 Lead Wire Sets per Heater
11/32" OUTSIDE NUT
11/32" INSIDE NUT
(SNUG TO CERAMIC)