Operation Manual






SPECIFICATIONS
Supply Voltage 230vAC +/- 10%
Maximum Load 2 kW
Operating Temperature -20°C to 30°C
IP Rating IP65
Gland Diameter Max Cable Entry 2.5mm²(Line & Load)
Temperature Set point 5°C to 25°C
FUSING
It is recommended to use an appropriately
rated mains fuse or D Type Breaker for
protection. On initial ‘switch on’ some loads
may increased Factor of Safety (F of S) for
Unit and/or Device protection. See SRA
Data sheet for further information.
CE MARKING
This family carries a “CE” marking. These phase angle controllers need a suitable remote filter. For
more information see rec section and contact our sales desk. (See Declaration of Conformity)
RECOMMENDATIONS
Other documents available on request, which may be appropriate for your application: -
CODE IDENTITY DESCRIPTION
X10229 RFI Single Phase Filtering recommendations - addressing EMC Directive
X10213 ITA Interaction, uses for phase angle and for burst fire control.
X10255 SRA Safety requirements - addressing the Low Voltage Directive
(LVD) including: - Thermal data/cooling; “Live” parts warning & Earth
requirements; Fusing recommendations.
AP02/4 COS UAL Conditions of sale.
NOTE It is recommended that installation and maintenance of this equipment
should be done wi
edition of the I.E.E. wiring regulations (BS7671) by suitably qualified/trained personnel.
The regulations contain important requirements regarding safety of electrical equipment
(F
I.E.C/ directive IEC 950).
UijthovenInfrarood
Nijverheidstraat31
4261TKWijkenAalburgTheNetherlands
Phone:0031416532724
Fax:0031416532719
E‐mail:[e-mail]

Web:www.terrastopper.nl
