User's Guide

UHFReader299 Demo Software User’s Guide V2.3
2
（1） the new reader address to set.
This address can't be 0xFF. If set 0xFF, reader will return error information.
（2） set and save power
configuration.
（3）
select the reader’s band, different band, the frequency is different.
（4） Set reader working
Min Frequency and Max Frequency. In different places, the radio requires the rule to be
different. Users can follow the local situation and choose to read more sensitive frequency
range of the card. In single frequency point operation, only need to set two frequencies to
the same value. In frequency hopping operation, only need to set two frequencies to the
different value.
（ 5 ） demo software start run,
default use the baud rate 57600 to open COM port, reader power on, reader baud rate
default is 57600. After change the baud rate, reader use the new baud rate until power off.
Close port and open port, the baud rate no change. The demo software will use the new
baud rate, until close the demo software.
（6） ，Set beep open or close
（7） ，click can get
reader’s serial number.
(8) ， select output port， click