User Manual

Installation Instructions

1. Record and document initial reading alignment readings.

2. Raise vehicle and remove wheel.

3. Mark position of original cam bolt.

NOTE: Replace one cam bolt assembly at a time.

4. Remove nut, washer and cam bolt.

5. Install new cam bolt in the same position as old bolt.

6. Install new nut and washer and tighten slightly.

7. Repeat steps 3 thru 8 for other cam bolt assembly.

8. Lower vehicle and continue with alignment.

9. Check and adjust toe.

ING3530-72897

CHEVROLET CORVETTE (REAR)

Cam bolt assembly

located on upper

control arm at inside

mount.

Replace one bolt at

a time.

CHRYSLER PRODUCTS

CAM BOLT

Cam bolt assembly located on lower control arm at inside mount.

FORD PRODUCTS

To release spring

tension place a

wedge between the

upper control arm

and the front cross

member