User's Manual

3. Recommendations

3.1. Security

IMP400 is specially designed for iSMP3 terminals charging.

 Do not short-circuit the metallic contacts.

 Do not attempt to open the product or the PSU.

 Do not attempt to replace the PSU by any other type even the characteristics

are similar.

 In case of abnormal behaviour disconnect the main power cord from the wall

plug.

Electrical power outlet and power cord:

 Power outlet must be installed near the equipment and easily accessible;

 Main plug of power cord must meet standards and regulations of the country it

is used in;

 The protection of the installation must be set to 20 A in US and Canada, 13 A in

the UK and 16 A in other countries.

WARNING

In such case all the certifications below and warranty for iSMP3 and IMP400

would be voided

3.2. Approvals and markings

Mandatory conformity marking for products sold within the

European Economic Area (EEA). It states that the product is

assessed before being placed on the market and meets EU

safety, health and environmental protection requirements

Indicates that the product has been certified to applicable

standards including standards written or administered by the

American National Standards Institute (ANSI), Underwriters

Laboratories (UL), CSA Group (CSA), NSF International (NSF),

and other North American and global organizations

Indicates that the product meet both American and Canadian

standards for safety requirements

Indicates that the product has been evaluated, tested and certified

for electrical safety by an independent accredited third-party

against German and European standards

Mandatory mark for Japan according to the Electrical Appliance

and Material Safety Law (DENAN)

Proof a regulated energy-using product imported into Canada has

been successfully tested and certified by an impartial and

independent Testing Laboratory accredited by the Standards

Council of Canada (SCC)