User's Guide

iWL2xx Wireless Series • 11/32 Copyright © 2011 Ingenico
900003061 R11 000 05/1122 All rights reserved
4.3. Installing Modules
4.3.1. SAM1/SAM2/SIM
CAUTION :
Switch off the terminal before opening the trapdoor.
The SAM/SIM connectors are located inside the terminal,
in a closed compartment.
• Turn the terminal and unclip the trapdoor by pushing on the
clips with your nails as shown with the arrows on the picture
• SAM1, SAM2 and SIM are identified by the engraved marks on
the lower housing
• When introducing a SAM/SIM in its slot, be sure to put the
cut corner as indicated on the picture
• Close the trapdoor.
TIP
Use a piece of adhesive tape to grip the SAM for easier and faster removal.
4.3.2. MicroSD M emory Card
CAUTION :
Switch off the terminal before opening the trapdoor.
MicroSD connector is located inside the terminal, in a closed
compartment.
To install a MicroSD Memory Card :
• Turn the terminal and unclip the trapdoor by pushing on the
clips with your nails as shown with the arrows on the picture
• Remove battery pack (disconnecting is not necessary).
• Insert the MicroSD Memory Card into th e conn ector slot as
shown on the figure.
Be sure to put the MicroSD contacts downside and the cut
corner as indicated on the figure.
• Close the trapdoor
The terminal supports MicroSD up to 32GB
Cut corner
position
SIM
SAM1 SAM2
Micro
SD card
Cut corner
position
iWL2xx Wireless Series • 12/32 Copyright © 2011 Ingenico
900003061 R11 000 05/1122 All rights reserved
To remove a MicroSD Memory Card :
• Turn the terminal and unclip the trapdoor by pushing on the clips
with your nails as shown with the arrows on the picture
• Remove battery pack (disconnecting is not necessary).
• Remove the MicroSD Memory Card. M icroSD connector has
push/pull ability . Push on MicroSD card edge to remove it.
• Close the trapdoor