User's Guide

ManualsBrandsINGENI ManualsElectronics3G and Contactless Point of Sales terminal

iWL2xx Wireless Series • 15/32

900003061 R11 000 05/1122

4.5. Battery

4.5.1.

Main characteristics

Ch aracteristics

Li-ion

Capacity 2050mAh

Ch arge

50% capacity in 1.5h; full capacity

in 4hours

Autonomy*

500 typical transactions

up to 250h in stand by

* depend on the terminal type and its base.

4.5.2.

Installing the battery

WARNING

Switch off the terminal prior to connecting the battery.

• Turn your terminal and unclip the battery trapdoor by

pushing on the clips with your nails as shown on the

picture

• Disengage the trapdoor

• Take the battery pack included in the box

• Locate the battery pack connector beside th e battery

compartment

• Plug the battery pack connector according to the

connector locating system and the red wire (as

shown on picture).

Verify th at it locks.

• Place the battery pack in its compartment.

• Check that the wires’ path is flat

• Close the battery compartment trapdoor.

Red wire

Battery compartment

iWL2xx Wireless Series • 16/32

900003061 R11 000 05/1122

4.5.3.

Charging the battery

 When does the battery need to be charged?

• On initial start up, charge the battery for 16 hours under the environmental

conditions stated above

• When used daily, the terminal recharges its batteries each time it is placed on its

base or each time the traveller charg er is connected. Charging is au tomatic

 How does the battery need to be charged?

• The environment in which the charge takes place influences battery lifetime and

autonomy (number of transactions)

The optimal conditions are as follows:

 Charging away from any external heat source (radiator, sun, enclosed area…)

 The optimal temperature is between +15°C and +25°C

 How can the battery be charged?

Using the base

• Place the terminal on its base

• Check if the battery symbol is flashing or moving (=battery charging).

Using the power travel adapter (the terminal is out of its base)

• Connect the traveller power supply unit to the terminal microAB connector located

on the left side of the terminal.

• Connect the power supply unit to the power supply mains network

• Check if the battery symbol is flashing or moving(=battery charging)