User's Guide

iWL2xx Wireless Series • 17/32

900003061 R11 000 05/1122

4.5.4.

Chang ing the battery

It is imperative to use a battery au thorized by Ingenico.

There is danger of explosion if battery used is not approved by Ingenico.

• Remove the terminal from its base

• Turn it off by pressing simultaneously and (yellow key) for

about one second

• Remove the battery trapdoor (see section 4.5.2“installing battery”)

• Lift the battery and remove it from its compartment

• Carefully disconnect battery, following the

instructions below.

a) Unlock the connector by pressing the locking

mechanism as indicated by F1 arrow while pulling

wires (F2 arrow ), to disconnect the connector.

Release traction on it as soon as the connector

comes unclipped

b) Finish extracting connector by tilting it slightly

(F3 arrow) to bring it away from the termin al

housing

• Connect and install the new battery by following the instructions in section 4.5.2

“Installing battery”

• Close the battery trapdoor and charge the new battery. See section "0 “Charging

the Battery"

• In order to preserve the environnement, dispose used battery in compliance with

current country recycling legislation.

• If the terminal is stored for a long time remove the battery from the terminal.

iWL2xx Wireless Series • 18/32

900003061 R11 000 05/1122

5. Base

IXL2xx Base is available in different models. Please select by yourself in this docu mentation

items related to your model.

WARNING

Turn off base power supply unit before connection operation.

5.1.1.

Base rear conn ections

WARNING

Select an electrical socket that complies with the gen eral safety instruction given in section

6 “Recommendations” of this document.

Follow the below instru ctions :

• Connect the power supply unit after all other connections.

• Connect the power supply unit to the base socket B.

• Connect the power supply unit to the mains network .

A = Ethernet socket (optional) B= power supply unit socket

C = Path for wires. D= USB Slave socket-CDC serial mode only (optional)

E = USB host Socket 1 (optional) F = USB host Socket 2 (optional)