User Guide

Move 3500

900019007 R11 000 06/0117

4_5_4 Changing the battery

It is imperative to use a battery authorized by Ingenico.

There is danger of explosion if battery used is not approved

by Ingenico.

Remove the terminal from its base

Turn it off by pressing simultaneously and (yellow

key) for about one second

Remove the battery trapdoor (see section 4.5.2“installing

battery”)

Carefully disconnect battery, following the instructions below.

Unlock the connector by

pressing the locking mechanism

as indicated by F1 arrow while

pulling this connector (F2 arrow ).

Release traction on it as soon as

the connector comes unclipped

Finish extracting connector

by tilting it slightly (F3 arrow)

to bring it away from the

terminal housing

Inform the terminal that battery will be replaced (*). Do so

start the terminal without battery by tting it on its base,

or connecting terminal power supply.

Remove terminal from base or disconnect terminal power

supply

Connect and install the new battery by following the

instructions in section 4.5.2 “Installing battery”

Close the battery trapdoor and charge the new battery.

See section «0 Charging the Battery»

In order to preserve the environnement, dispose used

battery in compliance with current country recycling

legislation.

(*)The terminal memorizes that there is no battery simply by powering

up. It will then correctly perform-full recharge with the next battery.