User Guide

Move 3500
900019007 R11 000 06/0117
Copyright© 2017 Ingenico
All rights reserved
23
The power supply label contains seven symbols :
Double insulation symbol
DC current output
AC current input
DC Power jack polarity
In door use only
International Ef ciency Marking Protocol (Energy
Star Level 5)
International Ef ciency Marking Protocol (Energy
Star Level 6)
The trapdoor for battery, SAM1/SAM2/SIM1/ (SAM3/SIM2),
readers located underneath the terminal, must be in place during
the normal operation of the terminal. See sections «Removal of
SAM1/SAM2/SIM, modules» as well as «Connecting the battery».
SAM1/SAM2/SIM1/(SAM3/SIM2) readers compartment
Your handset must be switched off by removing the battery pack.
Remove the battery from the terminal when on an airplane.
Non-compliance with these safety rules may result in legal action
and/or a ban on later access to cellular network services.
On airplanes
Certain regulations restrict the use of radio equipment in chemical
plants, fuel depots and any site where blasting is carried out. You
are urged to comply with these regulations. The terminal shall be
protected by a specially  tted and certi ed cover enabling use in
proximity to a fuel pump.
Explosion areas