Users Manual Part 3

ManualsBrandsINGENICO ManualsPOS EquipmentStandalone Payment Terminal

Lane/8000

900030066 R11 000 02/0119

5_1 Cleaning of the terminal

First of all, unplug all the wires from the terminal.

Good rules for proper cleaning of the terminal are :

Do not clean the electrical connections.

Avoid exposing the terminal to the direct rays of the sun.

Use a soft cloth that is very slightly sloated with soapy

water to clean the outside of the terminal.

Do not put anything into the slot of the smart card reader

5_2 Transport and storage

Disconnect all cables from the terminal during the

transport.

Use the original packaging for storage or returning the

unit.

5_3 Troubleshooting

Make sure that the Lane/8000 connector is fully inserted into

the back of the device.

Device is not working

Restart the device.

5_Maintenance

Before making any operations of maintenance in the

terminal, make sure that power supply is disconnected.

CAUTION

Do not use in any case, solvents, detergents or abrasive

products :

Those materials might damage the plastic or electrical

contacts.

CAUTION

Summary of content (8 pages)

PAGE 1
5_Maintenance CAUTION Before making any operations of maintenance in the terminal, make sure that power supply is disconnected. 5_1 Cleaning of the terminal First of all, unplug all the wires from the terminal. Good rules for proper cleaning of the terminal are : Use a soft cloth that is very slightly sloated with soapy water to clean the outside of the terminal. Do not clean the electrical connections. Avoid exposing the terminal to the direct rays of the sun.
PAGE 2
If you have another working Lane/8000 device, swap the devices to determine if the problem is with the device, cable, POS, or power supply. If the Lane/8000 device is directly connected to a host, reset the host by turning it off and back on again. Magnetic Card Reader Does Not Work Properly When sliding the card through the reader, make sure that the magnetic stripe on the card is facing the Lane/8000 display screen (see Swiping a Magnetic Stripe Card). Swipe the card at a faster or middle steady speed.
PAGE 3
6_Cables The terminal can be connected to the host by several ways, with optional cables: High speed USB device Ethernet RS232 Most of the cables used with iSC and iPP ranges are compatible with the Lane/8000. We advise to check with your reseller their compatibility if you plan to replace an iSC480 / ISC250 / ISC Touch 250 by a Lane/8000. Following are some examples of accessories that can be used to connect the Lane/8000 (ACC-LANE8000). This list is not exhaustive.
PAGE 4
HDMI / Ethernet (296100040AF) Power supply unit Connector for terminal Ethernet connector 7_Norms & Marking Lane 8000 CLESS FCC_ID IC_Number XKB-L8000CL 2586D-L8000CL 7_1 Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. 15.
PAGE 5
15.19 (a) (3) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : 1) This device may not cause harmful interference and 2) This device must accept any interference received, including interference that may cause undesired operation. 7_2 Industry Canada (IC) Statement. This device complies with Industry Canada licence-exempt RSS standard(s).
PAGE 6
(WEEE). Ingenico ensures that efficient collection and recycling schemes are set-up for WEEE according to the local regulation of your country. Please contact your retailers for more detailed information. Packaging waste must also be collected separately to assure a proper disposal and recycling. Please note that proper recycling of the WEEE will ensure safety of human health and environment.
PAGE 7
The RCM mark will be the only mark to indicate compliance with the Australian Communications and Media Authority’s (ACMA) regulatory arrangements for telecommunications, radio, EMC and electromagnetic energy (EME). The C-Tick is an identification trademark registered to the Australian Communications Media Authority (ACMA).
PAGE 8
“This Document is Copyright © 2019 by INGENICO Group. INGENICO retains full copyright ownership, rights and protection in all material contained in this document. The recipient can receive this document on the condition that he will keep the document confidential and will not use its contents in any form or by any means, except as agreed beforehand, without the prior written permission of INGENICO.