User's Manual
Table Of Contents
- Revision History
- 1 Overview
- 2 Safety and Regulatory Considerations
- 3 DC and RF Characteristics
- 4 Electrical Interface
- 5 Mechanical Information
- 6 Installation and Assembly Drawings
- 7 Provisioning
- Appendix A Provisioning Process and Work Flow
- Appendix B Test Mode
- Appendix C REACH Compliance Statements
- Appendix D Abbreviations and Terms
- Appendix E Raptor Mechanical Drawing and Schematics
Model EM110100 Integration Specification Installation and Assembly Drawings
On-Ramp Wireless Confidential and Proprietary 14 014-0026-00 Rev. A
Figure 7. Detail, Raptor Board Mounting
6.2.1 Assembly Torque Values
Two screws (P/N 9925887027, #4-24X.31 self-tapping, type BF Phillips pan-head steel zinc
screw) are required to mount Raptor in place. The screws have the following recommended
torque values: 6 to 7 in.-lbf.
6.3 Product Labels
The product label is shown in Figure 8.
NOTE: The TELEC ID number shown is NOT our number for this product. It is shown for
placement only.
An example of the carton label is shown in Figure 9.