User's Manual
Table Of Contents
- Contents
- 1 Overview
- 2 DC and RF Characteristics
- 3 Electrical Interface
- 4 Safety Considerations
- 5 Regulatory Considerations
- 6 Installation of TRN-2012/TRN-2113 Boards
- 7 Operating and Troubleshooting
- 8 Provisioning
- Appendix A Provisioning Process and Work Flow
- Appendix B Test Mode Interface
- B.1 Normal Operating Mode 0
- B.2 Non-Persistent Idle / Factory Test Mode 1
- B.3 Persistent Idle / Factory Test Mode 2
- B.4 Non-Persistent Node RF Test Mode 3
- B.5 Persistent Node RF Test Mode 4
- B.6 Non-Persistent Manufacturing Cal Mode 5
- B.7 Persistent Manufacturing Cal Mode 6
- B.8 Non-Persistent Meter Diagnostic Mode (Not Yet Implemented)
- B.9 Setting eMCM to Test Mode 1 - Non-Persistent Idle Factory Test Mode
- B.10 Setting eMCM to Test Mode 2 - Persistent Idle Factory Test Mode
- B.11 Setting eMCM to Test Mode 3 - Non-Persistent RF Test Mode
- B.12 Setting eMCM to Test Mode 4 - Persistent RF Test Mode
- Appendix C REACH Compliance Statements
- Appendix D Abbreviations and Terms
- Appendix E TRN-2012 / TRN-2113 Mechanical Drawings and Schematics
On-Ramp Wireless Confidential and Proprietary 5 014-0047-00 Rev. C
3 Electrical Interface
This chapter describes the electrical interface for the TRN-2012 (with internal antennas) and the
TRN-2113 (with external antennas).
3.1 Signal Connectors
Each side of the TRN-2012 and the TRN-2113 printed circuit boards is shown in Figure 2 and
Figure 3.
Figure 2. TRN-2012 with Internal Antennas (Top and Bottom Views)
Internal Antennas
2x 6-pin 0.1” Meter Interface Header