Specifications
Table Of Contents
- Revision History
- 1 Overview
- 2 DC and RF Characteristics
- 3 Electrical Interface
- 4 Safety Considerations
- 5 Regulatory Considerations
- 6 Installation of TRN-2013 Board
- 7 Provisioning
- Appendix A RF Test Mode Interface
- A.1 Normal Operating Mode 0
- A.2 Non-Persistent Idle / Factory Test Mode 1
- A.3 Persistent Idle / Factory Test Mode 2
- A.4 Non-Persistent Node RF Test Mode 3
- A.5 Persistent Node RF Test Mode 4
- A.6 Non-Persistent Manufacturing Cal Mode 5
- A.7 Persistent Manufacturing Cal Mode 6
- A.8 Non-Persistent Meter Diagnostic Mode (Not Yet Implemented)
- A.9 Setting eMCM to Test Mode 1 - Non-Persistent Idle Factory Test Mode
- A.10 Setting eMCM to Test Mode 2 - Persistent Idle Factory Test Mode
- A.11 Setting eMCM to Test Mode 3 - Non-Persistent RF Test Mode
- A.12 Setting eMCM to Test Mode 4 - Persistent RF Test Mode
- Appendix B REACH Compliance Statements
- Appendix C Abbreviations and Terms
- Appendix D TRN-2013 Mechanical Drawing and Schematics
On-Ramp Wireless Confidential and Proprietary 19 014-0057-00 Rev. B
6 Installation of TRN-2013 Board
The following figure shows how the TRN-2013 MCM is mounted inside the meter. Three screws
(P/N 9925887027, #4-24X.31 self-tapping, type BF Phillips pan-head steel zinc screw) are
required to mount TRN-2013 in place. The recommended torque values for the screws are 6 to 7
in.-lbf.
Figure 7. Meter Assembly with a TRN-2013 MCM
Three mounting screws