User's Manual

AP Deployment Guide - System Release 1.4 AP Software Configuration via Web Interface
On-Ramp Wireless Incorporated 29 010-0006-00 Rev. F
5. If the primary settings are good, you have the option to disable the Secondary Ethernet
address, if necessary, to avoid any IP address conflicts. To do this, click in the checkbox.
6. If the primary settings are incorrect:
a. Click the “Skip rollover to Secondary?” checkbox.
b. Change the primary settings
c. Go to step 2.
7.3.4 Ctrl Interface
The Ctrl Interface submenu (shown below) displays the settings for communicating with the TRN
Gateway.
NOTE: When editing the options on this screen, the AP must be in Offline status.
Table 9. Fields on the Ctrl Interface Submenu Screen
Field
Unit
Description
Socket Mode
N/A
Options for this field are as follows:
 Server: When the AP is set to work in Server mode, it listens for a TCP
connection with the Total Reach Gateway on port number
2021. See descriptions below for setting the following fields.
 Client: When the AP is set to work in Client mode, the AP requests
service from the Total Reach Gateway. See the field
descriptions below for setting the following fields.
NOTE: It is advisable to set the AP to Server mode first and configure it
in EMS to get the basic configurations. It can then be changed to
Client mode when the AP is added to the Gateway.