User's Manual

Access Point Product Specification Installation Prerequisites and Considerations
11 010-0021-00 Rev. G
Cable Type
Manufacturer Part
Number
RJ45 Connector
Type
Manufacturer Part
Number
CAT 6 STP Solid
10X8-591NH
www.CableWholesale.com
CAT 6 STP RJ45
Connectors, for
Solid Cable
CN150-45-10
Mfg: Abergetty
Supplied by:
www.deepsurplus.com
NOTE: It is very important that connectors be specified for the cable being used. As an example, if
using Cat5e solid conductor cable, the connectors should be specified for Cat5e solid
conductor cable. Some connectors are specified for both solid and stranded conductors.
Always use an RJ45 crimping tool that is specified for use with the connectors being used.
During the installation of the Ethernet cable, a pulling force of 25 pounds should not be exceeded.
The bending radius of the cable should never be less than four times its diameter. Ethernet cable
should not be deformed by tightly cinched cable ties.
Shielded Ethernet cable may be required in cases where the cable is installed in close proximity to
equipment or conductors generating strong electromagnetic fields. In this case follow Shielded
Twisted Pair (STP) installation guidelines.
3.2.8 Solar Power
Solar Power is recommended for sites where commercial power is not available or is not cost
effective to install. The required size for the solar panel and battery system is strongly influenced by
the geographic area in which it will be used. Ingenu offers a solar powered base station solution
that may be appropriate for your application. Contact Ingenu at [e-mail] for more
information.
3.2.9 Outdoor Installation Hardware
All outdoor installation hardware such as mounting brackets, pipe clamps, u-bolts, bolts, nuts and
washers should either be galvanized or stainless steel. This reduces deterioration due to corrosion,
oxidation, and rust.
NOTE: All exposed antenna system connectors must be sealed against moisture using industry
standard techniques.