User's Manual

Access Point Product Specification AP Software Configuration via Web Interface
30 010-0021-00 Rev. G
7.4.1 TRN Config Submenu
The Total Reach Network (TRN) Configuration screen (shown below) displays network
configuration parameters at the time the AP was deployed.
The following table defines the fields on this screen. To edit these fields, click on the Disable RF
button. After you make the changes, click on the Save button and then the Enable RF button.
NOTE: If you disable the RF, the AP is still connected to the Gateway.
Table 7. Fields on the Total Reach Network Configuration Screen
Field
Unit
Description
AP ID
Decima
l
The identification number for the AP. Range is 1 – 255.
Deployment Region ID
Decima
l
The identification number for the region where the AP is
deployed. Number range is 0 – 4228250625.
System ID
Decima
l
The System Identification Number. Range is 0 – 255.
Channel
Decima
l
The channel on which the AP communicates. Range is 1 – 40.
Reuse Code
Decima
l
Different Reuse Codes allow two APs to operate on the same
Channel and System ID without interference. Range is 0 – 255.