User's Manual

Access Point Product Specification AP Software Configuration via Web Interface
33 010-0021-00 Rev. G
The following table defines the fields on this screen. To edit these fields, click on the Disable RF
button. After you make the changes, click on the Save button and then the Enable RF button.
NOTE 1: If you disable the RF, the AP is still connected to the Gateway.
NOTE 2: The maximum transmit power for the AP and the Node is based on the setting in the
Regulatory Domain field.
Table 8. Parameters on the Field Configuration Screen
Field
Unit/Forma
t
Description
Reset Broadcast
Margin
Boolean
Resets the broadcast margin. The AP stays in this state until
the next time it is rebooted.
Force Scan Day
yyyy/mm/d
d
The date to perform a Force Scan.
RPMA Mode
N/A
Options are:
 Optimize Capacity
 Optimize Range (Default)
Online Duration
Without GPS Fix
seconds
The length of time allowed for the AP not to have a GPS fix.
The default is 600 seconds.
AP Transmit Parameters
(These parameters are based on regulatory domain, AP cable loss, and target excess SNR)
Regulatory Domain
string
The regulatory domain where the AP is deployed. The
regulatory domain limits the maximum transmit power for
the AP.
AP Maximum EiRP
Target
dBm
The maximum EiRP output targeted for the AP.
Cavity Filter
Boolean
The default value is set according to country-specific
regulatory requirements.
AP Cable Loss
dB
AP cable loss measured in dB.
AP Antenna Gain
dBi
This is the gain specified for the AP antenna installed.
AP Maximum Transmit
Power
dBm
This field is not editable. The value is determined by the
settings for the other AP Transmit Parameters.
Node Transmit Parameters
(These parameters are based on regulatory domain, Node cable loss, and target excess SNR)
Node Maximum EiRP
Target
dBm
The maximum EiRP output targeted for the Node.
Node Cable Loss
dB
Default setting is 0 dB. Contact Ingenu
([e-mail]) prior to changing this parameter.
Node Antenna Gain
dBi
Default setting is 2 dBi. Contact Ingenu
([e-mail]) prior to changing this parameter.
Node Maximum
Transmit Power
dBm
This field is not editable. The value is determined by the
settings for Regulatory Domain and the other Node Transmit
Parameters.