User's Manual

ULP EMS Operator Guide Maintaining and Operating the ULP Network
On-Ramp Wireless Confidential and Proprietary 9 010-0045-00
3. In the User ID field, type the user ID for this account. This is the same user ID that is entered
when logging in to the EMS with this new account.
4. In the First Name field, type the first name of the user for this account.
5. In the Last Name field, type the last name of the user for this account.
6. In the Password field, type the password for this account.
7. In the Confirm Password field, confirm the password entered above.
8. In the Phone field, type the phone number for the user for this account.
9. From the Assigned Role drop-down list, select the account type to use for this account.
10. Click Save.
NOTE:
A pop-up window may display depending on the password complexity used in Step 6
and Step 7 above. Make sure that the assigned password meets the password
complexity rules as described in the pop-up window.
3.3.2 Editing a User Account
To edit a user account, complete the following steps:
1. Log in to the EMS with an administrator account.
2. Click on the account to edit.
3. Change the account information.
4. Click Save.
3.4 Configuring the ULP Network
To configure the ULP network, configure and commission the following ULP elements:
 Gateway
 APs
 End devices (nodes)
To configure the ULP network, log in with an admin or configure account. When logging in with a
read-only account, the ULP network cannot be configured.
Operators can use the following methods to initialize the network:
 Ingest file
 Manual configuration
Operators can use a combination of these methods to initialize a network. For example, an
operator can start to initialize a network deployment of a small number of APs and nodes with
an ingest file. As APs and nodes are added to the network, the operator can add them through a
manual configuration.