User's Manual

ULP EMS Operator Guide Maintaining and Operating the ULP Network
On-Ramp Wireless Confidential and Proprietary 17 010-0045-00
5. In the Gateway Configuration window, complete the information for the following fields.
a. In the Name field, type a descriptive name for this Gateway.
b. In the Gateway Device Type field, type gw.
c. In the Upstream Control Socket Port (Numeric: 1024-65535) field, the default value is
4021. If the network does not use the default value, update the port value.
d. In the Upstream Control Socket Port Max Clients (Numeric 5-10) field, type 10.
e. In the Downstream Control Socket Port (Numeric: 1024-65535) field, type 5051.
f. In the Downstream Control Socket Port Max Client (Numeric: 1-254) field, type 254.
g. In the Upstream Data Socket Port (Numeric: 1024-65535) field, type 3025.
h. In the Upstream Data Port Max Clients (Numeric 5-10) field, type 10.
i. In the AP Timing Source field, select GPS from the drop-down list.
j. In the Secure Socket field, select enabled from the drop-down list.
k. In the Gateway Site Name (Max Length 127) field, type the site name for the Gateway.
l. In the Gateway Country Code (2 Characters) field, type the country code for the
Gateway.
m. Click Save.
NOTE:
If the operator has not changed any of the default settings and has clicked Save, the
following warning displays:
Cannot save configuration. No change has been made.
If changes have been made, a pop-up window asks for confirmation to restart.
Additionally, there is a place to enter an optional note about this configuration
change. All EMS configuration changes are logged to an audit report. The
information here is logged in this report with the configuration change.
6. The pop-up window asks the operator to confirm the restart.
7. Click Yes. The pop-up window asks the operator to confirm the restart.
8. Click Yes.
9. In the Device selection pane, click on the GW ID of the Gateway that was added. The
Gateway Configuration window is displayed.